D-Link DXS-3600 Series Cli Reference Manual page 844

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This MSTP hello-time only takes effect in the MSTP mode.
Example
This example shows how to configure the port hello-time to 1 for the Ethernet interface Ethernet 1/01.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# spanning-tree mst hello-time 1
Switch(config-if)#
70-9 spanning-tree mst priority
This command is used to configure the bridge priority value for the selected MSTP instance. Use the no
command to return the setting to the default setting.
spanning-tree mst INSTANCE-ID priority PRIORITY
no spanning-tree mst INSTANCE-ID priority
Parameters
INSTANCE-ID
PRIORITY
Default
By default, this value is 32768.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The priority has same meaning with as the bridge priority in the STP command reference, but can specify
a different priority for distinct MSTP instances.
Example
This example shows how to configure the bridge priority for the MSTP instance 2.
Switch# configure terminal
Switch(config)# spanning-tree mst 2 priority 0
Switch(config)#
Specifies the MSTP instance identifier. Instance 0 represents the
default instance, CIST.
Specifies the bridge priority value that must be divisible by 4096. The
range is from 0 to 61440.
839