D-Link DXS-3600 Series Cli Reference Manual page 501

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
39-9 sub-ring
This command is used to specify the sub-ring default instance of a physical ring default instance. Use the
no command to remove the sub-ring default instance of a physical ring default instance.
sub-ring SUB-RING-NAME
no sub-ring SUB-RING-NAME
Parameters
SUB-RING-NAME
Default
None.
Command Mode
ERP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Configure a sub-ring connected to another ring. This command is applied on the interconnection node.
Example
This example shows how to configure the physical ring named "ring2" as a sub-ring of "ring1".
Switch# configure terminal
Switch(config)# ethernet ring g8032 ring2
Switch(config-erp)# exit
Switch(config)# ethernet ring g8032 ring1
Switch(config-erp)# sub-ring ring2
Switch(config-erp)#
39-10 sub-ring instance
This command is used to specify the sub-ring instance of a physical ring instance. Use the no command
to remove the sub-ring instance of a physical ring instance.
sub-ring instance INSTANCE-ID
no sub-ring instance INSTANCE-ID
Parameters
INSTANCE-ID
Default
None.
Specifies the G8032 sub-ring's name.
Specifies the identifier of an ERP instance. The valid range is from 1 to
32.
496