D-Link DXS-3600 Series Cli Reference Manual page 580

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# no interface loopback2
Switch (config)#
47-4 interface range
This command is used to enter the interface range configuration mode for multiple interfaces.
interface range INTERFACE-ID [,|-]
Parameters
INTERFACE-ID
,
-
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command enters the interface configuration mode for the specified range of interfaces. Commands
configured in the interface range mode, applies to interfaces in the range.
Example
This example shows how to enter the interface configuration mode for the range of ports 2/0/1 to 2/0/5:
and port 3/0/3.
Switch# configure terminal
Switch(config)# interface range Ethernet 2/0/1-5, 3/0/3
Switch(config-if-range)#
47-5 show counters
This command is used to display interface information.
show counters [interface INTERFACE-ID]
Parameters
Specifies the ID of the interface. The interface ID is formed by interface
type and interface number with no spaces in between.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces are allowed before and
after the comma.
(Optional)Specifies a range of interfaces. No spaces are allowed
before and after the hyphen.
575