D-Link DXS-3600 Series Cli Reference Manual page 898

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to enable or disable the acceptance of an authorized configuration. When
authorization is enabled for authentication, the authorized attributes (for example VLAN, 802.1p default
priority, bandwidth, and ACL) assigned by the RADIUS server will be accepted if the authorization status
is enabled. Bandwidth and ACL are assigned on a per-port basis. If in the multi-auth mode, VLAN and
802.1p are assigned on a per-host basis. Otherwise, Bandwidth and ACL are assigned on a per-port
basis.
Example
This example shows how to disable the authorization status.
Switch# configure terminal
Switch(config)# no authorization disable
Switch(config)#
73-13 show authentication sessions
This command is used to display authentication information.
show authentication sessions [mac | wac | dot1x | interface INTERFACE-ID [, | -] [mac | wac |
dot1x] | mac-address MAC-ADDRESS]
Parameters
mac
wac
dot1x
interface INTERFACE-ID
,
-
mac-address MAC-ADDRESS
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Specifies to display all MAC sessions.
Specifies to display all WAC sessions.
Specifies to display all dot1x sessions.
(Optional) Specifies a port to display.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
(Optional) Specifies to display a specific user.
893