D-Link DXS-3600 Series Cli Reference Manual page 1405

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
The default exponential weight factor is 9.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the WRED exponential weight factor for the average queue size
calculation for the queue.
Example
This example shows how to configure the exponent value to 10 on Ethernet 1/0/1 queue 5.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# random-detect exponential-weight 5 exponent 10
Switch(config-if)#
122-5 random-detect profile
This command is used to configure the WRED profile. Use the no form of this command to reset to the
default setting.
random-detect profile ID [tcp | non-tcp] [green | yellow | red] min-threshold VALUE max-
threshold VALUE max-drop-rate VALUE
no random-detect profile ID
Parameters
profile ID
tcp
non-tcp
green
yellow
red
min-threshold VALUE
max-threshold VALUE
max-drop-rate VALUE
Default
None.
Command Mode
Global Configuration Mode.
Specifies the ID of the WRED profile that will be set.
Specifies the WRED drop parameters for the TCP packets to be set.
Specifies the WRED drop parameters for non-TCP packets to be set.
Specifies the WRED drop parameters for green packets to be set.
Specifies the WRED drop parameters for yellow packets to be set.
Specifies the WRED drop parameters for red packets to be set.
Specifies the minimum queue size (in cells) to start WRED dropping.
Specifies the maximum queue size (in cells) over which WRED will
drop all packets destined for this queue.
Specifies the drop probability when the average queue size reaches
the maximum threshold. When this value is zero, then the packet will
not be dropped or remarked for ECN.
1400