D-Link DXS-3600 Series Cli Reference Manual page 800

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to change the MLD version on the specified interface. Use the no form of the
command to revert to the default setting.
ipv6 mld version {1 | 2}
no ipv6 mld version
Parameters
1
2
Default
The default MLD version is 2.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is only available for the VLAN interface configuration. The user can use this command to
modify the MLD query version on an interface.
Example
This example shows how to configure the MLD version 1.
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ipv6 mld version 1
Switch(config-if)#
67-10 show ipv6 mld groups
This command is used to display MLD group information on an interface.
show ipv6 mld groups [GROUP-ADDRESS | interface INTERFACE-ID] [detail]
Parameters
GROUP-ADDRESS
interface INTERFACE-ID
detail
Default
None.
Command Mode
Specifies to configure the switch to run MLD version 1.
Specifies to configure the switch to run MLD version 2.
(optional) Specifies to display the group IPv6 address. If no IPv6
address specified, all MLD group information will be displayed.
(optional) Specifies the interface to display. If no interface is specified,
MLD group information about all interfaces will be displayed.
(Optional) Specifies to display the detailed group information.
795