Show Ip Ospf Neighbor - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Designated Router (ID) 222.200.23.2, Interface Address 2.0.0.2
Backup Designated Router (ID) 222.200.23.1, Interface Address 2.0.0.1
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Current Authentication Type: md5
Authentication Key Configuration
Authentication type: md5
Message-digest-key 1
Total Entries : 2
Switch#
75-38

show ip ospf neighbor

This command is used to display information of OSPF neighbors.
show ip ospf neighbor [interface INTERFACE-ID | neighbor NEIGHBOR-ID] [detail] [vrf VRF-
NAME]
Parameters
INTERFACE-ID
NEIGHBOR-ID
detail
vrf VRF-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display information of OSPF neighbors. If no interface type or number is specified,
OSPF neighbor information of all interfaces will be displayed.
Example
This example shows how to display information of OSPF neighbors.
Switch# show ip ospf neighbor
Neighbor ID
-------------------------------------------------------------------------------
110.2.2.2
15.15.15.15
110.1.1.1
32.44.67.200
(Optional) Specifies the interface ID to display.
(Optional) Specifies the Neighbor ID.
(Optional) Specifies to display detailed information of neighbors.
(Optional) Specifies the IPv4 OSPF VRF process.
Pri State
1 Full/DR
1 2-Way/DROther
1 Exchange/Backup 00:00:39
1 Full/DR
935
Dead Time Address
00:00:38 10.10.9.2
00:00:38 10.22.8.100
10.90.90.90
00:00:39 21.44.67.200
Interface
vlan1
vlan1
vlan1
vlan2