D-Link DXS-3600 Series Cli Reference Manual page 511

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
In addition to these configurations, the configuration of service protected VLANs and RPL related settings
are fundamental for operation of an ERP instance.
Example
This example shows how to activate the major ring instance 1.
Switch# configure terminal
Switch(config)# ethernet ring g8032 major-ring
Switch(config-erp)# instance 1
Switch(config-erp-instance)# profile campus
Switch(config-erp-instance)# activate
Switch(config-erp-instance)#
39-18 timer
This command is used to configure timers for an ERP domain. Use the no form of this command to reset
the timer to the default setting.
timer {guard MILLI-SECONDS | hold-off SECONDS | wtr MINUTES}
no timer {guard | hold-off | wtr}
Parameters
guard MILLI-SECONDS
hold-off SECONDS
wtr MINUTES
Default
The default guard timer is 500 milliseconds.
The default hold-off timer is 0.
The default WTR timer is 5 minutes.
Command Mode
G.8032 Profile Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the timers to be used by ERP instances associated with the profile. Use
the no command to reset the timer to the default setting. If no option is specified for the no command, all
timers will be reset.
Example
This example shows how to configure the guard timer to 700 milliseconds, hold-off timer to 1, and WTR
timer to 1 minute for profile "campus".
Switch# configure terminal
Switch(config)# ethernet ring g8032 profile campus
(Optional) Specifies the guard timer in milliseconds. The valid range is
from 10 to 2000. The value should be multiples of 10.
(Optional) Specifies the hold-off timer in seconds. The valid range is
from 0 to 10.
(Optional) Specifies the WTR timer in minutes. The valid range is from
1 to 12.
506