D-Link DXS-3600 Series Cli Reference Manual page 829

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# mvlan
Switch(config)# mvlan 100
Switch(config-mvlan)# replace-source-ip ipv4 1.10.10.10 from receiver
Switch(config-mvlan)# replace-source-ip ipv6 FE80:3000::3 from source
Switch(config-mvlan)#
69-8 mvlan group-profile
This command is used to create a group profile for the multicast VLAN feature. Use the no form of this
command to remove a group profile or all group profiles.
mvlan group-profile PROFILE-NAME
no mvlan group-profile {PROFILE-NAME | all}
Parameters
PROFILE-NAME
all
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
A profile is used to define group address ranges. It will be used by multicast VLANs to check which
multicast VLAN should be replaced through matching the group in the IGMP/MLD packet.
Example
This example shows how to create a profile named "mv_profile1".
Switch# configure terminal
Switch(config)# mvlan group-profile mv_profile1
Switch(config-mvlan-profile)#
69-9 access-group
This command is used to bind an access group profile to a multicast VLAN. Use the no form of this
command to remove the binding.
access-group PROFILE-NAME
no access-group PROFILE-NAME
Parameters
Specifies the name of the profile.
Specifies to remove all multicast VLAN profiles.
824