D-Link DXS-3600 Series Cli Reference Manual page 1252

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
-
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the Spanning Tree configuration for the single spanning tree when in the
RSTP or STP-compatible mode.
Example
This example shows how to display the spanning tree information when STP is enabled.
Switch#show spanning-tree
Spanning Tree: Enabled
Protocol Mode: RSTP
Tx-hold-count: 6
NNI BPDU Address: dot1d(01-80-C2-00-00-00)
Root ID Priority: 32768
Address: 00-00-00-11-22-33
Hello Time: 2 sec, Max Age: 20 sec, Forward Delay: 15 sec
Bridge ID Priority: 32768 (priority 32768
Address: 00-00-00-11-22-33
Hello Time: 2 sec, Max Age: 20 sec, Forward Delay: 15 sec,
Topology Changes Count: 0
Interface
---------
eth1/0/3
eth1/0/5
eth1/0/6
eth1/0/7
Switch#
103-3 show spanning-tree configuration interface
This command is used to display the information about STP interface related configuration.
show spanning-tree configuration interface [INTERFACE-ID [, | -]]
Parameters
comma.
(Optional) Specifies a range of interfaces. No space before and after
the hyphen.
Role State
---- -----
designated forwarding 20000
backup blocking
backup blocking
root forwarding 2000
1247
sys-id-ext 0)
Priority Link
Cost .Port# Type
---- ------- -----
128.3 p2p
200000 128.5 p2p
200000 128.6 shared non-edge
128.7 P2p
Edge
----
non-edge
non-edge
non-edge