D-Link DXS-3600 Series Cli Reference Manual page 1020

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only valid for the VLAN interface. This command only takes effect when the interface is
PIM-SM enabled.
When configuring the Join/Prune interval, the user needs to consider the factors, such as configured
bandwidth and expected average number of multicast route entries for the attached network or link (for
example, the period would be longer for lower-speed links, or for routers in the center of the network that
expect to have a larger number of entries).
For SM-mode, the router will periodically send the join message based on this interval. The hold-time in a
Join/Prune message is 3.5 times the join-prune-interval. The receiving router will start a timer based on
this hold-time, and prune the interface if no join message is received on this interface.
Example
This example shows how to configure the PIM Join/Prune timer to 120 seconds on interface VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 pim join-prune-interval 120
Switch(config-if)#
82-8 ipv6 pim passive
This command is used to specify an interface running in the passive mode. Use the no form of the
command to disable passive mode.
ipv6 pim passive
no ipv6 pim passive
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command only takes effect when the interface is IPv6 PIM enabled. When the passive mode is
enabled, the interface will neither send PIM messages out nor accept PIM messages from this interface.
The router will act as it is the only PIM router on the network. Use this command only when there is only
one PIM router on the LAN.
Example
1015