D-Link DXS-3600 Series Cli Reference Manual page 723

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to enable advertising Port and Protocol VLAN ID TLV. The advertised VLAN
includes 1 to 3.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp dot1-tlv-select protocol-vlan 1-3
Switch(config-if)#
This example shows how to enable the VLAN Name TLV advertisement from vlan1 to vlan3.
Switch# configure terminal
Switch(config)#interface ethernet 1/0/1
Switch(config-if)#lldp dot1-tlv-select vlan-name 1-3
Switch(config-if)#
This example shows how to enable the LACP Protocol Identity TLV advertisement.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp dot1-tlv-select protocol-identify lacp
Switch(config-if)#
61-4 lldp dot1-tlv-select dcbx
This command is used to specify which optional type-length-value settings (TLVs) in the Data Center
Bridging Exchange protocol (DCBX) TLV set will be transmitted and encapsulated in the LLDPDUs and
sent to neighbor devices. To disable the transmission of TLVs, use the no form of this command.
lldp dot1-tlv-select dcbx [ets-configuration | ets-recommendation | pfc-configuration]
no lldp dot1-tlv-select dcbx [ets-configuration | ets-recommendation | pfc-configuration]
Parameters
ets-configuration
ets-recommendation
pfc-configuration
Default
By default, no DCBX TLV is selected and the DCBX state machine is enabled.
Command Mode
Interface Configuration Mode.
(Optional) Specifies the Enhanced Transmission Selection
Configuration TLV to send. The Enhanced Transmission Selection
Configuration TLV is an optional TLV that allows a bridge port to
advertise the current ETS operational state and willing bit.
(Optional) Specifies the Enhanced Transmission Selection
Recommendation TLV to send. The Enhanced Transmission Selection
Recommendation TLV is an optional TLV that allows a bridge port to
advertise the ETS recommendation for the operational state of the
remote port.
(Optional) Specifies the Priority-based Flow Control Configuration TLV
to send. The Priority-based Flow Control TLV is an optional TLV that
allows a bridge port to advertise the PFC current operational state and
willing bit.
718