D-Link DXS-3600 Series Cli Reference Manual page 1077

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
By default, 4, 7, 11, 14, 18, 21, 25 (in percentage) are assigned for Traffic Classes 0 to 6.
By default, 0 is assigned for Traffic Class 7 which means that the transmission selection algorithm is
"strict priority".
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The ETS bandwidth assignment only takes effect when the scheduling mode is ETS.
Example
This example shows how to assign available bandwidth to traffic classes for the ETS scheduling mode on
interface Ethernet 1/0/3. This example allocates 10%, 20%, 30%, and 40% available bandwidth to traffic
classes 0 to 3. Assign traffic class 4 to 7 to strict priority.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/3
Switch(config-if)# mls qos scheduler ets
Switch(config-if)# ets-queue bandwidth 10 20 30 40 0 0 0 0
Switch(config-if)#
86-4 mls qos scheduler ets
This command is used to configure the queue scheduling to the Enhanced Transmission Selection (ETS)
mode.
mls qos scheduler ets
Parameters
None.
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
ETS is defined in IEEE 802.1Qaz. ETS provides an operational model for priority processing and
bandwidth allocation in the switches in a DCB environment. Using priority-based processing and
bandwidth allocations, different traffic classes with different types of traffic such as LAN, Storage
Networking, Clustering, and management can be configured to provide bandwidth allocation or best effort
number of zero stands for strict priority mode.
1072