Ip Igmp Version - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# ip access-list CHANNEL-2
Switch(config-ip-acl)# permit any 232.1.1.2 255.255.255.255
Switch(config-ip-acl)# exit
Switch(config)# ip igmp ssm-map static CHANNEL-1 10.1.1.1
Switch(config)# ip igmp ssm-map static CHANNEL-2 10.2.1.1
Switch(config)#
49-10 ip igmp static-group
This command is used to create a static membership on an interface for a group or a channel. Use the no
form of the command to remove the membership.
ip igmp static-group GROUP-ADDRESS
no ip igmp static-group GROUP-ADDRESS
Parameters
GROUP-ADDRESS
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command allows the user to create an IGMP static group in case that when the attached host does
not support the IGMP protocol. Once configured, the group member entry is added to the IGMP cache.
Example
This example shows how to configure a static IGMP group entry on VLAN 1000.
Switch# configure terminal
Switch(config)# interface vlan1000
Switch(config-if)# ip igmp static-group 238.1.1.2
Switch(config-if)#
49-11

ip igmp version

This command is used to change the IGMP version on the specified interface. Use the no form of the
command to revert to the default setting.
ip igmp version {1 | 2 | 3}
no ip igmp version
Specifies the IP multicast group address.
640