D-Link DXS-3600 Series Cli Reference Manual page 1145

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to define a clause to match the route's metric. Use the no command to remove the
clause.
match metric VALUE
no match metric
Parameters
VALUE
Default
None.
Command Mode
Route-map Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command in the route map configure mode to define a rule for matching routes' metric.
Example
This example shows how to create a route map entry to match against the metric of routes.
Switch# configure terminal
Switch(config)# route-map myPolicy permit 1
Switch(config-route-map)# match metric 10
Switch(config-route-map)#
91-6 match route-type
This command is used to specify the RIP version to be sent on an interface basis. Use the no command
to revert to the default setting.
match route-type {internal | external [type-1 | type-2]}
no match route-type {internal | external [type-1 | type-2]}
Parameters
internal
external
type-1
type-2
Default
Specifies the metric of route. The range is from 0 to 4294967294.
Specifies the intra-area and inter-area routes of Open Shortest Path
First (OSPF).
Specifies the autonomous system's external route of OSPF. If the
type-1 and type-2 options are not specified, type-1 and type-2
external routes are included.
(Optional) Specifies the type-1 external route of OSPF.
(Optional) Specifies the type-2 external route of OSPF.
1140