D-Link DXS-3600 Series Cli Reference Manual page 1377

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
VC Statistics:
RX Bytes: 0, RX Packets: 0
TX Bytes: 0, TX Packets: 0
VC ID: 4, Peer IP Address: 160.1.1.2, Operate Status: Standby, Backup
Name: BACKUP_VC_TO_PE2
Description: This is backup VC to PE2
Backup Delay: Never
Local AC: eth1/0/1-VLAN4, Status: Up
VLAN mode: Add VLAN20, 802.1q tunneling Ethernet Type: 0x8100
Remote AC Status: Up
MPLS VC Labels: Local 18, Remote 18
Outbound Tunnel label: 102
MTU: Local 1500, Remote 1500
Group ID: Local 0, Remote 0
Signaling Protocol: LDP
Local VCCV Capabilities:
CC: Type 2
CV: LSP ping
Remote VCCV Capabilities:
CC: Type 2
CV: LSP ping
VC Statistics:
RX Bytes: 0, RX Packets: 0
TX Bytes: 0, TX Packets: 0
Total Entries: 2
Switch#
118-9 vlanmode
This command is used to configure the VLAN mode of the PW. Use the no command to reset the VLAN
mode of the PW to the default setting.
vlanmode {nochange | addvlan VLAN-ID | changevlan VLAN-ID}
no vlanmode
Parameters
nochange
addvlan VLAN-ID
changevlan VLAN-ID
Default
Specifies not to change of the VLAN tag on the ingress packet. This
can only be applied on Ethernet VLAN-based ACs.
Specifies to add the configured VLAN tag to the ingress packet. The
default action for port-based ACs is to add the VID of 0. This can be
applied on both Ethernet-based and Ethernet VLAN-based ACs. Enter
the VLAN ID after the keyword here.
Specifies to change the VLAN tag of the ingress packet to the
configured VLAN ID. This can only be applied on Ethernet VLAN-
based AC. Enter the VLAN ID after the keyword here.
1372