D-Link DXS-3600 Series Cli Reference Manual page 789

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Usage Guideline
Use this command to display MLD snooping information for all VLANs on which MLD snooping are
enabled by not specifying specific VLAN.
Example
This example shows how to display MLD snooping configurations.
Switch# show ipv6 mld snooping
MLD snooping global state: Enabled
VLAN #1 configuration
MLD snooping state
Minimum version
Fast leave
Report suppression
Suppression time
Proxy Reporting
Mrouter port learning : Enabled
Querier state
Query version
Query interval
Max response time
Robustness value
Last listener query interval
Rate limit
Ignore topology change : Disabled
Total Entries: 1
Switch#
66-19 show ipv6 mld snooping filter
This command is used to display MLD snooping filter information for all interfaces on the switch or for a
specified interface.
show ipv6 mld snooping filter [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID [,|-]
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
: Enabled
: v2
: Enabled (host-based)
: Enabled
: 10 seconds
: Disabled
: Enabled (Non-active)
: v2
: 125
: 10 seconds
: 2
: 1 second
: 50
(Optional) Specifies the interface(s) to be displayed. The interface(s)
can be a physical interface or a port-channel. If no interface is
specified, this command will display MLD snooping filter information on
all interface, at which MLD snooping is enabled.
784