D-Link DXS-3600 Series Cli Reference Manual page 869

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch#
This example shows how to display the MPLS's global settings.
Switch# show mpls
MPLS Status
LSP Trap Status
Switch#
71-31 show mpls forwarding-table
This command is used to display the MPLS label forwarding path information.
show mpls forwarding-table [ip NETWORK-PREFIX/PREFIX-LENGTH] [detail]
Parameters
ip NETWORK-
PREFIX/PREFIX-LENGTH
detail
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays the MPLS forwarding path information.
Example
This example shows how to display all MPLS label forwarding path information.
Switch# Show mpls forwarding-table
LSP FEC
---- -------------
1 201.1.1.0/24
2 201.2.1.0/24
3 172.1.1.1/32
4 192.1.1.0/24
Total Entries: 4
Switch#
: Enabled
: Disabled
(Optional) Specifies the IP prefix FEC. If not specified, display all
FECs.
Specifies to display detailed information of the MPLS label forwarding
path information.
In Label Out Label
-------- ---------
1020 1030
1060 1040
1050 -
- 1070
864
Out Interface Next Hop
------------- ---------------
VLAN 10 172.18.1.1
VLAN 20 192.1.1.2
VLAN 10 172.18.1.1
VLAN 10 172.18.1.1