D-Link DXS-3600 Series Cli Reference Manual page 516

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
•
Supports the configuration of the sending of a R-APS PDU destination address with the physical
ring's ring ID.
Before specifying G.8032v1 for a G.8032v2 device, changing the ERPS version will lead to the restart of
the running protocol.
If Ethernet ring nodes running ITU-T G.8032v1 and ITU-T G.8032v2 co-exist on an Ethernet ring, the
following configurations should be met on the G.8032v2 device:
•
All physical ring IDs have the default value of 1.
•
Interconnection node's major ring and sub-ring instances must have different R-APS VIDs.
•
Manual switch or force switch commands not exist.
•
Physical rings have only one instance.
Example
This example shows how to set the ERPS version.
Switch# configure terminal
Switch(config)# erps version G.8032v1
Switch(config)#
39-25 snmp-server enable traps erps
This command is used to enable the sending of SNMP notifications for ERPS state changes. Use the no
command to disable the sending of SNMP notifications.
snmp-server enable traps erps
no snmp-server enable traps erps
Parameters
None.
Default
By default, this feature is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enable the sending of SNMP notifications for ERPS state changes or RPL
owner conflict events.
Example
This example shows how to enable the sending of traps for ERPS events.
Switch# configure terminal
Switch(config)# snmp-server enable traps erps
Switch(config)#
511