D-Link DXS-3600 Series Cli Reference Manual page 1384

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
VRID
Default
By default, the preempt mode is used.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
In preempt mode, a router will take over the master role if it has a better priority than the current master.
In non-preempt mode, the master will not be preempted unless the incoming router is the IP address
owner of the virtual router.
Example
This example shows how to configure the router for VRRP group 7 to preempt the current master router
when its priority is higher than that of the current master router.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# vrrp 7 preempt
Switch(config-if)#
119-7 vrrp bfd
This command is used to configure the VRRP Bidirectional Forwarding Detection (BFD) peer address.
Use the no command to delete the VRRP BFD peer address.
vrrp VRID bfd fast-detect peer IP-ADDRESS
no vrrp VRID bfd fast-detect peer IP-ADDRESS
Parameters
VRID
fast-detect
peer IP-ADDRESS
Default
By default, no BFD peer address is configured.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Specifies the virtual router identifier that identifies the VRRP group.
The valid range is from 1 to 255.
Specifies the virtual router identifier. The range of value is from 1 to
255.
Specifies to configure the BFD fast detection feature.
Specifies the IP address of the BFD peer.
1379