Xconnect Vfi - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
The VLAN mode will affect the VLAN handling of the encapsulated packet for all PWs that belong to this
VPLS. The TPID of the added or changed VLAN tag can be configured with the dot1q tunneling
ethertype command.
This command can only be applied on VPLS of which the PW type is tagged.
Example
This example shows how to configure the VLAN mode to change the VLAN tag to 20.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)# vlanmode changevlan 20
Switch(config-vfi)#
117-14 vpn id
This command is used to configure the VPN ID of a VPLS.
vpn id VPN-ID
Parameters
VPN-ID
Default
By default, the VPN ID is 0.
Command Mode
VFI Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the VPN ID of a VPLS. Each VPLS in a device should have a local
unique VPN ID.
Example
This example shows how to configure the VPN ID of a VPLS to 100.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)# vpn id 100
Switch(config-vfi)#
117-15

xconnect vfi

This command is used to create a local AC in a VPLS. Use the no command delete a local AC from a
VPLS.
xconnect vfi VPLS-NAME
Specifies the VPN ID of a VPLS. The value range is from 1 to
4294967295.
1362