D-Link DXS-3600 Series Cli Reference Manual page 1048

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
default
ACCESS-LIST
Default
By default, PIM-SSM is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command only affects PIM-SM operation. Use this command on the last hop of the router only.
When SSM is enabled, the last hop router will initiate to establish a source-based tree for the channel
(S,G) on receiving a IGMPv3 include (S, G) request that falls in the SSM range from the attached hosts.
Example
This example shows how to configure an IP standard access list and specifies the defined group address
as the SSM range.
Switch# configure terminal
Switch(config)# ip access-list SSM-GROUP
Switch(config-ip-acl)# permit any 224.2.0.0 0.0.255.255
Switch(config-ip-acl)# exit
Switch(config)# ip pim ssm range SSM-GROUP
Switch(config)#
83-16 show ip pim
This command is used to display the PIM global information.
show ip pim
Parameters
None.
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Specifies to use the default SSM group addresses. The default SSM
group address range is 232/8.
Specifies the standard IP access list that defines the user-specified
SSM group addresses. The group address should be defined in the
destination IP address field of the rule entry.
1043