Virtual Router Redundancy Protocol (Vrrp) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
119. Virtual Router Redundancy Protocol
(VRRP) Commands
119-1 snmp-server enable traps vrrp
This command is used to enable the VRRP trap function in SNMP. Use the no command to disable this
function.
snmp-server enable traps vrrp [new-master] [auth-fail]
no snmp-server enable traps vrrp [new-master] [auth-fail]
Parameters
new-master
auth-fail
Default
By default, this feature is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable the VRRP trap state. If no option is specified, then both trap types are
enabled or disabled at the same time.
Example
This example shows how to enable the VRRP new master trap state.
Switch# configure terminal
Switch(config)# snmp-server enable traps vrrp new-master
Switch(config)#
119-2 vrrp authentication
This command is used to enable VRRP authentication and set the password on an interface. Use the no
form of this command to remove the authentication.
vrrp authentication STRING
no vrrp authentication
(Optional) Specifies the new master trap status that will be configured.
If the trap status is enabled, once the device has transitioned to the
master state, a trap will be sent out.
(Optional) Specifies the authentication failure trap status that will be
configured. If the trap status is enabled, if a packet has been received
from a router whose authentication key or authentication type conflicts
with this router's authentication key or authentication type, then a trap
will be sent out.
1375