D-Link DXS-3600 Series Cli Reference Manual page 672

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This example shows how to display information for tunnel 3.
Switch#show interface tunnel3
tunnel3 is enabled, link status is up
Interface type is tunnel
Interface Description:
Tunnel mode is ipv6ip
Tunnel source 20.0.0.3(VLAN1), destination 11.76.2.3
Tunnel TTL is inherited from IPv6 hop limit
IPv6 address 3ffe:22:33:44::55/64
Switch#
52-6 show ipv6 interface
This command is used to display IPv6 interface information.
show ipv6 interface [INTERFACE-ID ]
Parameters
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If an interface is not specified, then all existing interfaces will be displayed.
Example
This example shows how to display information for tunnel 0.
Switch # show ipv6 interface tunnel0
Tunnel is enabled, Link status is down
Tunnel mode is ipv6ip isatap
IPv6 is disabled,
Global unicast address:
3ffe:501:ffff:100:a01:2ff:fe39:1/64
Switch#
Specifies the interface that will be displayed.
667