D-Link DXS-3600 Series Cli Reference Manual page 1095

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
CoS Value:
DSCP Value:
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The DSCP to CoS map is used by a DSCP trust port to map a DSCP value to an internal CoS value. In
turn this CoS value is then mapped to the CoS queue based on the CoS to queue map configured by the
priority-queue cos-map command.
Example
This example shows how to configure the DSCP to CoS map for mapping DSCP 12, 16, and 18 to CoS 1
for Ethernet 1/0/6.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/6
Switch(config-if)# mls qos map dscp-cos 12,16,18 to 1
Switch(config-if)#
87-10 mls qos map dscp-mutation
This command is used to define a named Differentiated Services Code Point (DSCP) mutation map. To
remove the mutation map, use the no form of this command.
mls qos map dscp-mutation MAP-NAME INPUT-DSCP-LIST to OUTPUT-DSCP
no mls qos map dscp-mutation MAP-NAME
Parameters
MAP-NAME
INPUT-DSCP-LIST
OUTPUT-DSCP
Default
The output DSCP is equal to the input DSCP.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
0 1 2 3
0-7 8-15 16-23 24-31
Specifies the name of the DSCP mutation map in a string length up to
32 characters (no space is allowed)
Specifies the list of DSCP code point to be mutated to another DSCP
value. The range is from 0 to 63. A series of DSCPs can be separated
by commas (,) or hyphens (-). No space or hyphen is before and after.
Specifies the mutated DSCP value. Valid values are from 0 to 63.
4 5 6
32-39 40-47 48-55
1090
7
56-63