Debug Ip Ospf Spf - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
None.
Default
By default the OSPF packet transmitting debug switch is turned off.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on or turn off the OSPF packet transmitting debug switch. When one OSPF
protocol packet is sent out, the debug information will print if the OSPF debug function is turned on.
Example
This example shows how to turn on the OSPF packet transmitting debug switch.
Switch# debug ip ospf packet-transmitting
Switch#
Send out a Hello on interface 10.1.1.1 dst 255.0.0.5 tic 200
Send out a Hello on interface 100.1.1.1 dst 255.0.0.5 tic 220
75-47

debug ip ospf spf

This command is used to turn on the OSPF SPF calculation debug switch. Use the no form of the
command to turn off the OSPF SPF calculation debug switch.
debug ip ospf spf
no debug ip ospf spf
Parameters
None.
Default
By default the OSPF SPF calculation switch is turned off.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on or turn off the OSPF SPF calculation debug switch. When one SFP
calculation is processing, the debug information will print if the OSPF debug function is turned on.
Example
This example shows how to turn on the OSPF SPF calculation debug switch.
Switch# debug ip ospf spf
Switch#
942