D-Link DXS-3600 Series Cli Reference Manual page 969

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to configure an IPv6 OSPF routing process and enter the router configuration
mode. To remove an OSPF routing process, use the no form of this command.
ipv6 router ospf PROCESS-ID
no ipv6 router ospf PROCESS-ID
Parameters
PROCESS-ID
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enter the OSPF for IPv6 router configuration mode. From this mode, you can
configure other settings of IPv6 OSPF.
Example
This example shows how to enable the router configuration mode of IPv6 OSPF. The process ID is 1.
Switch# configure terminal
Switch(config)# ipv6 router ospf 1
Switch(config-rtr)#
76-17 no area
This command is used to remove the specific area that has been created.
no area AREA-ID
Parameters
AREA-ID
Default
None.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Specifies the ID for an IPv6 OSPF routing process. It is locally
assigned and should be unique for each IPv6 OSPF routing process
on the router. The range of value is from 1 to 65535.
Specifies the ID of the area.
964