Priority-Based Flow Control (Pfc) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

80. Priority-based Flow Control (PFC) Commands

80-1 clear priority-flow-control counters
This command is used to clear the Priority-based Flow Control (PFC) counters of the specified
interface(s).
clear priority-flow-control counters {all | INTERFACE-ID [, | -]} {rx | tx | both}
Parameters
all
INTERFACE-ID
,
-
rx
tx
both
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to clear the PFC counters of requests and indications on the specified interface(s).
Example
This example shows how to clear the counters of transmitted PFC frames on the interface Ethernet 1/0/1.
Switch# clear priority-flow-control counters ethernet 1/0/1 tx
Switch#
80-2 priority-flow-control willing
This command is used to turn on the DCBX PFC willing feature which indicates that the local port is
willing to accept PFC configurations from a remote system.
priority-flow-control willing
no priority-flow-control willing
Specifies to clear PFC counters on all interfaces.
(Optional) Specifies the interface(s) used.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and after
the hyphen.
Specifies to clear the counter of received PFC frames.
Specifies to clear the counter of transmitted PFC frames.
Specifies to clear the counter of received and transmitted PFC frames.
997