D-Link DXS-3600 Series Cli Reference Manual page 820

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
The total times of this peer
transfer into Up state
Incoming filter
Outgoing filter
Request filter
Minimum TTL for data-
encapsulated SA message
The number of SAs learned
from this peer.
The maximum number of SAs
can be learned from this peer.
Count of RPF check failure
Incoming/Outgoing control
messages
Incoming/Outgoing SA
messages
Incoming/Outgoing SA
requests
Incoming/Outgoing SA
responses
68-23 show ip msdp sa-cache
This command is used to display SA cache information.
show ip msdp sa-cache [group GROUP-ADDRESS] [source SOURCE-ADDRESS] [rp RP-
ADDRESS]
Parameters
group GROUP-ADDRESS
source SOURCE-ADDRESS
rp RP-ADDRESS
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display SA cache information.
The total times the MSDP state transitioned into the "Up" state
The SA message incoming filter configured on this MSDP peer.
The SA message outgoing filter configured on this MSDP peer.
The SA request message filter configured on this MSDP peer.
The minimum TTL of an encapsulation packet is required to have
before it may be forwarded to this peer.
The number of SAs learned from this peer.
The maximum number of SAs can be learned from this peer.
The number of SA messages received from this peer that failed the
Peer-RPF check.
The number of MSDP messages, excluding encapsulated data
packets which are received from this peer and the number of those
transmitted to this peer.
The number of MSDP SA messages which are received from this peer
and the number of those transmitted to this peer.
The number of MSDP SA request messages which are received from
this peer and the number of those transmitted to this peer.
The number of MSDP SA response messages which are received from
this peer and the number of those transmitted to this peer.
Specifies to display the Source-Active cache by group address.
Specifies to display the Source-Active cache by source address.
Specifies to display the Source-Active cache by RP address.
815