D-Link DXS-3600 Series Cli Reference Manual page 426

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
channel 4
Switch#
29-2 snmp-server enable traps transceiver-monitoring
This command is used to enable the sending of all or individual optical transceiver monitoring SNMP
notifications. Use the no command to disable the sending of all or individual optical transceiver monitoring
SNMP notifications.
snmp-server enable traps transceiver-monitoring [alarm] [warning]
no snmp-server enable traps transceiver-monitoring [alarm] [warning]
Parameters
alarm
warning
Default
By default, this feature is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Issuing this command with no parameters, will enable or disable all transceiver-monitoring SNMP
notifications.
Example
This example shows how to enable the sending of warning level notifications.
Switch# configure terminal
Switch(config)# snmp-server enable traps transceiver-monitoring warning
Switch(config)#
29-3 transceiver-monitoring action shutdown
This command is used to shut down a port from an alarm or a warning of an abnormal status.
Use the no form of the command to disable the shutdown action.
transceiver-monitoring action shutdown {alarm | warning}
no transceiver-monitoring action shutdown
Parameters
16.794(++)
(Optional) Specifies to enable or disable the sending of alarm level
notifications.
(Optional) Specifies to enable or disable the sending of warning level
notifications.
421