D-Link DXS-3600 Series Cli Reference Manual page 570

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
GROUP-ADDRESS
INTERFACE-ID
,
-
Default
By default, no static-group is configured.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. This command applies to IGMP
snooping on a VLAN interface to statically add group membership entries and/or source records.
The ip igmp snooping static-group command allows the user to create an IGMP snooping static group
in case that the attached host does not support the IGMP protocol.
Example
This example shows how to statically add a group and source records for IGMP snooping.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping static-group 226.1.2.3 interface ethernet 1/0/5
Switch(config-vlan)#
46-18 ip igmp snooping suppression-time
This command is used to configure the interval of suppressing duplicate IGMP reports or leaves. Use the
no form of the command to revert to the default setting.
ip igmp snooping suppression-time SECONDS
no ip igmp snooping suppression-time
Parameters
SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Interface Configuration Mode.
Specifies a IP multicast group address.
(Optional) Specifies an interface or an interface list. The interface can
be a physical interface or a port-channel.
(Optional) Specifies a series of interfaces, or a separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Specifies to configure the interval of suppressing duplicates IGMP
reports. The range is from 1 to 300.
565