D-Link DXS-3600 Series Cli Reference Manual page 1305

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
show logging [all | [REF-SEQ] [+ NN | - NN]]
Parameters
all
REF-SEQ
+ NN
- NN
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the system messages logged in the local message buffer.
Each message logged in the message buffer is associated with a sequence number. As a message is
logged, a sequence number starting from 1 is allocated. The sequence number will roll back to 1 when it
reaches 100000.
When the user specifies to display a number of messages following the reference sequence number, the
oldest messages are displayed prior to the newer messages. When the user specifies to display a
number of messages prior to the reference sequence number, the newer messages are displayed prior to
the later messages.
If the command is issued without options, the system will display up to 200 entries starting from the latest
message.
Example
This example shows how to display the messages in the local message buffer.
Switch# show Switch# show logging
Total number of buffered messages: 2
#2 2015-03-25 16:37:36 Unit 1, Successful login through Console (Username: Anonymous)
#1 2015-03-25 16:35:54 INFO(6) Port eth1/0/1 link up, 1000Mbps FULL duplex
Switch#
110-10 show attack-logging
This command is used to display attack log messages.
show attack-logging unit UNIT-ID [index INDEX]
Specifies to display all log entries starting from the latest message.
Specifies to start the display from the reference sequence number.
Specifies the number of messages that occurred after the specified
reference sequence number. If the reference index is not specified, it
starts from the eldest message in the buffer.
Specifies the number of messages that occurred prior to the specified
reference sequence number. If the reference index is not specified, the
message display starts from the last message written in the buffer.
1300