D-Link DXS-3600 Series Cli Reference Manual page 1383

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
119-5 vrrp timers advertise
This command is used to configure the interval between successive VRRP advertisements by the master
router. To restore the default value, use the no form of this command.
vrrp VRID timers advertise INTERVAL
no vrrp VRID timers advertise
Parameters
VRID
INTERVAL
Default
By default, this value is 1 second.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The maser will constantly send VRRP advertisements to communicate the related information of the
current master virtual router. This command configures the interval between advertisement packets and
the time before other routers declare the master router as down. All routers in a VRRP group must use
the same timer values.
Example
This example shows how to configure the router to send advertisements for VRRP 7 every 10 seconds on
interface VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# vrrp 7 timers advertise 10
Switch(config-if)#
119-6 vrrp preempt
This command is used to allow a router to take over the master role if it has a better priority than the
current master. Use the no form of the command to change back to non-preempt mode.
vrrp VRID preempt
no vrrp VRID preempt
Parameters
Specifies the virtual router identifier that identifies the VRRP group.
The valid range is from 1 to 255.
Specifies the time interval between successive advertisements by the
master router. The unit of the interval is in seconds. The valid value is
from 1 to 255.
1378