Gvrp Timer - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
-
Default
No VLANs are forbidden.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is available for both physical ports and port-channel interface configuration. As a forbidden
port of a VLAN, a port is forbidden from becoming a member port of the VLAN via the GVRP operation.
The VLAN specified by the command does not need to exist.
This command only affects the GVRP operation. The setting only takes effect when GVRP is enabled.
The command only takes effect for hybrid mode and trunk mode.
Example
This example shows how to configure the interface Ethernet 1/0/1 as a forbidden port of VLAN 1000 via
the GVRP operation.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# gvrp forbidden 1000
Switch(config-if)#

43-7 gvrp timer

This command is used to configure the GVRP timer value on a port. Use the no form of the command to
revert the timer to the default setting.
gvrp timer [join TIMER-VALUE] [leave TIMER-VALUE] [leave-all TIMER-VALUE]
no gvrp timer [join] [leave] [leave-all]
Parameters
join
leave
leave-all
TIMER-VALUE
Default
Join: 20.
comma.
(Optional) Specifies a range of VLANs. No spaces are required before
and after the hyphen.
(Optional) Specifies to set the timer for joining a group. The unit is in a
hundredth of a second.
(Optional) Specifies to set the timer for leaving a group. The unit is in a
hundredth of a second.
(Optional) Specifies to set the timer for leaving all groups. The unit is in
a hundredth of a second.
Specifies the timer value in a hundredth of a second. The valid range
is 10 to 10000.
539