D-Link DXS-3600 Series Cli Reference Manual page 896

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# authentication username mac-format case uppercase delimiter hyphen
number 5
Switch(config)#
73-10 authentication max users
This command is used to configure the maximum authenticated users for the entire system or for a port.
Use the no form of the command to reset to default setting.
authentication max users NUMBER
no authentication max users
Parameters
NUMBER
Default
None.
Command Mode
Global Configuration Mode.
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command can be used in the global configuration mode and interface configuration mode.
If the command is configured in the global configuration mode, the maximum user number limits the user
number of the entire system.
If the command is configured in the interface configuration mode, the maximum user number is set for the
interface.
The maximum users being limited include 802.1X, MAC-based Access Control, and WAC users.
In addition, the command has the following limitation:
•
If the new maximum is less than the current number of users, the command will be rejected and
the error message will be prompted.
Example
This example shows how to set the maximum authenticated users for system.
Switch# configure terminal
Switch(config)# authentication max users 256
Switch(config)#
73-11 authentication mac-move deny
This command is used to enable MAC move on the switch. Use the no form of this command to return to
the default setting.
Specifies to set the maximum authenticated users' number. The range
is from 1 to 4096.
891