Debug Ip Ospf - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
75-39 show ip ospf virtual-links
This command is used to display virtual link information.
show ip ospf virtual-links [vrf VRF-NAME]
Parameters
vrf VRF-NAME
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display virtual link information.
Example
This example shows how to display virtual link information.
Switch#show ip ospf virtual-links
Virtual Link to router 10.90.90.90 is up
Transit area 0.0.0.3 via interface vlan40
Local address 4.0.0.1
Remote address 4.0.0.2
Transmit Delay is 1 sec, State Point-To-Point
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Adjacency state Full
Current Authentication Type: md5
Authentication Key Configuration
Authentication type: md5
message-digest-key 1
Total Entries : 1
Switch#
75-40

debug ip ospf

This command is used to turn on the OSPF debug function. Use the no form of this command to turn off
the OSPF debug function.
debug ip ospf
(Optional) Specifies the IPv4 OSPF VRF process.
937