D-Link DXS-3600 Series Cli Reference Manual page 892

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Level: 12.
Usage Guideline
When the inactivity timer is configured, a user session will be terminated if the session sustains no activity
for the configured period of time. If the inactivity timer is configured, it should be shorter than the timer
value configured by authentication timer re-authentication command.
Example
This example shows how to configure the inactivity timer to 240 for Ethernet 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# authentication timer inactivity 240
Switch(config-if)#
73-5 authentication timer reauthentication
This command is used to configure the timer to re-authenticate a session. Use the no form of the
command to revert the setting to default.
authentication timer reauthentication {SECONDS}
no authentication timer reauthentication
Parameters
SECONDS
Default
By default, this value is 3600 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the re-authentication timer.
Example
This example shows how to configure the re-authentication timer value to 200 for Ethernet 1/0/1.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# authentication timer reauthentication 200
Switch(config-if)#
73-6 authentication timer restart
This command is used to configure the timer to restart the authentication after the last failed
authentication. Use the no form of the command to revert the setting to default.
Specifies the timer to re-authenticate a session. The range is from 1 to
65535.
887