D-Link DXS-3600 Series Cli Reference Manual page 946

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch# debug ip ospf lsa-flooding
Switch#
Received LSA type 1 id 2.2.2.2 from nbr 2.2.2.2 in area 0.0.0.0 seq 80000001 csum fe3a
tic 15
Flood LSAs in area 0.0.0.0 tic 15
75-45 debug ip ospf packet-receiving
This command is used to turn on the OSPF packet receiving debug switch. Use the no form of the
command to turn off the OSPF packet receiving debug switch.
debug ip ospf packet-receiving
no debug ip ospf packet-receiving
Parameters
None.
Default
By default the OSPF packet receiving debug switch is turned off.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to turn on or turn off the OSPF packet receiving debug switch. When one OSPF
protocol packet is received, the debug information will print if the OSPF debug function is turned on.
Example
This example shows how to turn on the OSPF packet receiving debug switch.
Switch# debug ip ospf packet-receiving
Switch#
Received a Hello packet from addr 10.1.1.2 at interface System tic 100
Received a Hello packet from addr 100.1.1.2 at interface ip100 tic 102
75-46 debug ip ospf packet-transmitting
This command is used to turn on the OSPF packet transmitting debug switch. Use the no form of the
command to turn off the OSPF packet receiving debug switch.
debug ip ospf packet-transmitting
no debug ip ospf packet-transmitting
Parameters
941