D-Link DXS-3600 Series Cli Reference Manual page 1368

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
no xconnect vfi VPLS-NAME
Parameters
VPLS-NAME
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create a local AC in a VPLS in the interface configuration mode. A local AC
could be an Ethernet-based AC which is created in the Ethernet interface or an Ethernet VLAN-based AC
which is created in the interface service configuration mode. All local ACs in a VPLS should have same
AC type. All VLAN-based local ACs in a VPLS should have the same encapsulation service VLAN.
Example
This example shows how to create a local AC, which is an Ethernet-based AC and the Ethernet port is
1/0/1 into a VPLS which name is "vpls100".
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# xconnect vfi vpls100
Switch(config-if-xconn)#
This example shows how to create a local AC, which is an Ethernet VLAN-based AC and the Ethernet
port is 2/0/1 and VLAN is 100 into a VPLS which name is "vpls200".
Switch# configure terminal
Switch(config)# interface ethernet 2/0/1
Switch(config-if)# service encapsulation svid 100
Switch(config-if-srv)# xconnect vfi vpls200
Switch(config-if-xconn)#
(Optional) Specifies the VPLS name. This name can be up to 32
characters long.
1363