D-Link DXS-3600 Series Cli Reference Manual page 1130

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
88-10 show qcn cpid
This command is used to display the relationship between the CP identifier, interface, and CP index.
show qcn cpid CP-IDENTIFIER
Parameters
CP-IDENTIFIER
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the corresponding interface ID and CP index for the specified CP Identifier.
This CP index is an arbitrary integer indexing the entries in the CP table among the entries for the same
interface. This value is the corresponding queue ID plus 1.
Example
This example shows how to display the interface ID and CP index for CP identifier, 0011223344550101.
Switch# show qcn cpid 0011223344550101
CP-Identifier
QCN Component Id
Interface Index
CP-Index
Switch#
Specifies the 16 hexadecimal digits for the Congestion Point Identifier
(CPID) to get the corresponding interface ID and CP index.
: 0011223344550101
: 1
: eth1/0/1
: 1
1125