Stacking Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
104.

Stacking Commands

104-1 stack
This command is used to enable the daisy-chain stacking function and use the no stack command to
disable the daisy-chain stacking function.
stack
no stack
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
The ports on a stackable switch unit, used to chain with other switch units, can either work as stacking
ports or work as ordinary Ethernet ports based on the setting of the stack command. The stack command
setting of a switch unit must be enabled before the switch unit can be chained with other switch units. The
setting will be saved in the individual switch unit if the user saves the configuration.
Example
This example shows how to enable stacking mode.
Switch# stack
WARNING: The command does not take effect until the next reboot.
Switch#
104-2 stack renumber
This command is used to manually assign a unit ID to a switch unit. Use the no form of the command to
set the unit ID of the switch to auto-assigned.
stack CURRENT-UNIT-ID renumber NEW-UNIT-ID
no stack CURRENT-UNIT-ID renumber
Parameters
CURRENT-UNIT-ID
NEW-UNIT-ID
Specifies the switch unit being configured.
Specifies the new unit ID assigned to the switch.
1260