D-Link DXS-3600 Series Cli Reference Manual page 1165

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config)# router rip
Switch(config-router)# redistribute ospf
Switch(config-router)#
93-12 router rip
This command is used to configure the RIP routing process. To disable the RIP routing process, use the
no form of this command.
router rip
no router rip
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enter the Router Configuration Mode of the RIP protocol and enable the RIP
function. The no command will remove the configuration in the RIP router mode and disable RIP process.
Example
This example shows how to begin the RIP routing process.
Switch# configure terminal
Switch(config)# router rip
Switch(config-router)#
93-13 show ip rip database
This command is used to display the Routing Information Protocol (RIP) routing database.
show ip rip database [IP-ADDRESS MASK | NETWORK-PREFIX/PREFIX–LENGTH] [vrf VRF-
NAME]
Parameters
IP-ADDRESS MASK
NETWORK-PREFIX/PREFIX-
LENGTH
metric 10
(Optional) Specifies the address of the routing information that should
be displayed.
(Optional) Specifies the subnet prefix and the prefix length of the
network to be displayed.
1160