Ipv6 Router Rip - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The metric refers to the hop count. By default, when receiving an IPv6 RIP route, a metric value of 1 is
added to the route before it is inserted into the routing table. Use this command to influence the metric of
routes received on different interface and thus influence the preference of the route.
Example
This example shows how to configure a metric increment of 3 for routes received on VLAN 1.
Switch# configure terminal
Switch(config)# interface vlan1
Switch(config-if)# ipv6 rip metric-offset 3
Switch(config-if)#

94-6 ipv6 router rip

This command is used to configure the IPv6 RIP routing process. To remove an IPv6 RIP routing process,
use the no form of this command.
ipv6 router rip
no ipv6 router rip
Parameters
None.
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to enter the Router Configuration Mode for IPv6 RIP routing process. Use the no
form of the command to remove an IPv6 RIP routing process.
Example
This example shows how to configure an IPv6 RIP routing process.
Switch# configure terminal
Switch(config)# ipv6 router rip
Switch(config-rtr)#
1168