Intermediate System To Intermediate System (Is-Is) Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
48. Intermediate System to Intermediate System
(IS-IS) Commands
48-1 address-family ipv6
This command is used to enter the IPv6 address family configuration mode to configure the settings
specific to the address family. Use the no command to remove the configuration of the specified IPv6
address family.
address-family ipv6 [unicast]
no address-family ipv6 [unicast]
Parameters
unicast
Default
None.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
None.
Example
This example shows how to enter the address family configuration mode for the IPv6 address family.
Switch# configure terminal
Switch(config)# router isis
Switch(config-router)# address-family ipv6
Switch(config-router-af)#
48-2 adjacency-check
This command is used to enable the supported protocol consistency checks when forming adjacencies.
To disable the checks, use the no form of this command.
adjacency-check
no adjacency-check
Parameters
None.
(Optional) Specifies to use IPv6 unicast address prefixes. This is the
default.
589