D-Link DXS-3600 Series Cli Reference Manual page 1284

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
URL
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
When using the boot image command, the associated specified boot image file will be the startup boot
image file for the next reboot. Use this command to assign a file as the next-boot image file. The system
will check the model and checksum to determine whether the file is a valid image file.
The purpose of the check parameter is for checking the file information to let the user understand
whether the specified file is suitable to be a boot image or not. The setting of the boot image command
will immediately be stored in the NVRAM, which is a space separated from the start-up configuration.
The backup image is decided automatically and is the newest valid image other than the boot-up one.
NOTE: If the boot image file is damaged, the Switch will automatically use the backup image file
in the next boot up. This change will not be indicated in the show boot command.
Example
This example shows how to specify that the switch should use the image file named 'switch-image1.had'
as the boot image file for the next startup.
Switch# configure terminal
Switch(config)# boot image c:/switch-image1.had
Switch(config)#
This example shows how to check a specified image file called "c:/runtime.switch.had". The checksum of
the image file has been verified is okay and the information of the image file is displayed.
Switch# configure terminal
Switch(config)# boot image check c:/runtime.switch.had
----------------------
Image information
----------------------
Version: 2.40.046
Description: D-Link Corporation TenGigabit Ethernet Switch
Switch(config)#
This example shows how to checks a specified image file called "runtime.wrongswitch.had". The
checksum of the image file has been verified wrong and an error message is displayed.
Switch# configure terminal
Switch(config)# boot image check runtime.wrongswitch.had
ERROR: Invalid firmware image.
Switch(config)#
Specifies the URL of the file to be used as the boot image file.
1279