D-Link DXS-3600 Series Cli Reference Manual page 1294

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
109-11 show running-config
This command is used to display the commands in the running configuration file.
show running-config [effective | all] [interface INTERFACE-ID]
Parameters
effective
all
interface INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command displays the current running system configuration.
Example
This example shows how to display the content of the running configuration file.
Switch# show running-config
Building configuration...
Current configuration : 149304 bytes
#-------------------------------------------------------------------------------
#
#
#
#
#
#-------------------------------------------------------------------------------
# STACK
end
stack preempt
end
(Optional) Specifies to display command configurations that affect the
behavior of the device. All other lower layer settings of STP are not
displayed. The lower layer settings will only be displayed when the
higher layer settings are enabled.
(Optional) Specifies to display all command configurations, including
commands that corresponds to default parameters.
Specifies to display command configurations corresponding to the
specified interface.
DXS-3600-28SC Gigabit Ethernet Switch
Firmware: Build 2.40.041
Copyright(C) 2015 D-Link Corporation. All rights reserved.
Configuration
1289