D-Link DXS-3600 Series Cli Reference Manual page 1158

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
vrf VRF-NAME
Default
None.
Command Mode
Router Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enter the address family configuration mode to configure the command. Use the
exit command to leave address family configuration mode and return to router configuration mode without
removing the existing configuration.
Example
This example shows how to enter and exit address family configuration mode for the VRF "branch-route"
address family.
Switch# configure terminal
Switch(config)# router rip
Switch(config-router)# address-family ipv4 vrf branch-route
Switch(config-router-af)# exit
Switch(config-router)#
93-3 default-metric (RIP)
This command is used to configure the value to be used as the default metric for routes redistributed to
RIP. To return to the default value, use the no form of the command.
default-metric METRIC-VALUE
no default-metric
Parameters
METRIC-VALUE
Default
By default, this value is 0.
Command Mode
Router Configuration Mode.
Router Address Family Configuration (RIP) Mode.
Command Default Level
Level: 12.
Specifies the name of the VRF instance to enter VRF address family
configuration mode.
Specifies the default metric value. The valid range of values is from 1
to 16.
1153