D-Link DXS-3600 Series Cli Reference Manual page 1053

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Total Entries: 4
Switch#
83-20 show ip pim rp mapping
This command is used to display group-to-RP (rendezvous point) mappings and the RP set.
show ip pim rp mapping
Parameters
None.
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display active rendezvous points (RPs) that are cached with associated multicast
routing entries. This command is used to display the RP mapping information viewed by the router
Example
This example shows how to display group-to-RP (rendezvous point) mappings and the RP set.
Switch# show ip pim rp mapping
Group(s): 224.0.0.0/4
RP: 90.1.1.3
Info source: 90.1.1.3, via bootstrap, priority 0
Uptime: 0DT16H52M39S, expires: 0DT00H02M50S
Group(s): 225.0.0.0/8
RP: 1.1.1.10
Info source: static
Switch#
Display Parameters
RP
Info source
Via bootstrap
Priority
Uptime
The address of the RP for the group specified.
Indicates from which system the router learned this RP information.
The RP mapping information is learned from the BSR.
The RP priority.
The length of time (in day, hours, minutes, and seconds) that the
1048