System File Management Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
109.

System File Management Commands

109-1 boot config
This command is used to specify the file that will be used as the configuration file for the next boot.
boot config URL
Parameters
URL
Default
By default, the config.cfg file is used.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
The command is used to specify the startup configuration file. The default startup configuration file is
config.cfg. If there is no valid configuration file, the device will be configured to the default state.
Example
This example shows how to configure the file 'switch-config.cfg' as the startup configuration file.
Switch# configure terminal
Switch(config)# boot config c:/switch-config.cfg
Switch(config)#
109-2 boot image
This command is used to specify the file that will be used as the image file for the next boot.
boot image [check] URL
Parameters
check
NOTE: If the boot configuration file is damaged, the Switch will automatically revert back to the
default configuration.
Specifies the URL of the file to be used as the startup configuration
file.
(Optional) Specifies to display the firmware information for the
specified file. This information includes the version number and model
description.
1278