D-Link DXS-3600 Series Cli Reference Manual page 1052

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Address
PIM
Mode
Neighbor Count
DR
DR Priority
Generation ID
Hello Interval
Join Prune Timer
PIM Passive Mode
Total Entries: 3
Switch#
83-19 show ip pim neighbor
This command is used to display the PIM-SM neighbor information.
show ip pim neighbor [INTERFACE-ID]
Parameters
INTERFACE-ID
Default
None.
Command Mode
User EXEC or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to determine which routers on the LAN are configured for PIM.
Example
This example shows how to display the PIM neighbor information on all interfaces.
Switch# show ip pim neighbor
Mode: DR - Designated Router, N - Default DR Priority,
G – Generation ID
Neighbor
--------------------------------------------------------------------------------
10.10.0.9
10.10.0.136
10.10.0.172
192.168.0.100
: 12.1.1.1
: Enabled
: Sparse-Dense
: 0
: 12.1.1.1
: 1
: 9e3d65
: 30 seconds
: 60 seconds
: Disabled
(Optional) Specifies the interface to display PIM-SM neighbor
information. If the interface ID is not configured, information on all
interfaces will be displayed.
Interface Uptime/Expires
vlan1 0DT00H55M33S/0DT00H01M44S
vlan1 0DT00H55M20S/0DT00H01M25S
vlan1 0DT00H55M33S/0DT00H01M32S
vlan2 0DT00H55M30S/0DT00H01M20S
1047
Ver DR Pri/Mode
v2 1 /G
v2 1 /G
v2 1 /DR,G
v2 N /G